Instruction Manual

READ ALL INSTRUCTIONS BEFORE USE!

Initial Set Up Procedures

1. Make sure the bottom brace is flat on the ground, then loosen the knob on the rear leg and allow the bottom portion of the leg to go to the ground at the PW position on standard lie. Then adjust the bottom leg that is attached to the flat guide and make sure it is flat on the ground.

2. Always Adjust Height of the guides before each golfer uses. This is the most important step before practice swings. This is most important for the safety of the golfer and for the effectiveness of the machine.

3. Always keep top guides as close together as possible to prevent golfer from over cocking wrist at top of swing and having club head come out of guides.

Please do not attempt to hit balls before reading the entire instruction manual. It is not suggested to hit balls until a golfer has spent 30 – 60 minutes minimum of practice swings in the machine. When first attempting to hit balls always open the bottom front guides to maximum width.

Adjusting the height for each golfer

• Stand in the machine at address position with club. Take a very slow backswing making sure your hands do not touch the guides or the machine throughout to the top of the swing.
• Adjust top guides down by sliding black PVC into machine after loosening black knob (near your left knee) until the guides are close to your hands with a fully extended backswing, while maintaining spine tilt. Then tighten black knob (near your left knee) to hold the black PVC in place.

Adjusting to each club

Remember to make sure the bottom brace is flat on the ground, then loosen the knob on the rear leg and allow the bottom portion of the leg to go to the ground at the PW position on standard lie. Then adjust the bottom leg that is attached to the flat guide and make sure it is flat on the ground.

Loosen the knob on the back bracket; which holds the rear leg in place using the sticker located on the bracket set to the desired club. For players that are fitted to 1 – 2 degrees upright or flat, use the corresponding markings on the leg. When you have the arm set to proper position retighten knob.

Adjusting Swing Plane

To adjust the degree of the swing plane; use rear swing plane adjuster knob. Turning the knob to the right will increase the swing plane angle above the shaft plane angle, to more of an upright position. Turning the knob to the left will decrease the swing plane angle to a flatter position. Use the gauge reference #’s to remind you of your setting for future practice. After making this adjustment always adjust front guide using bottom two knobs to keep the guides close to each other but not touching.

Adjusting to Two Plane Swing

To adjust to a 2-plane swing, turn “2 Plane Adjuster Knob” inward to increase to a more upright position for the top half of the swing. After making this adjustment always adjust front guide using front adjustment knobs to keep the guides close to each other but not touching.

Adjusting top of swing slider

To adjust stopper for top of swing simply move slider to desired stop position at the top of swing.

Adjusting Front Guides

ADJUST GUIDES TO MAXIMUM WIDTH WHEN HITTING BALLS

To adjust front guides closer for practice swings that are more consistent, turn front adjuster knobs to the left until the front guide is in the desired position. Do not close so tightly that the front guide is touching the rear guide.